Making a paddle bow at Gregs
Moderator: Moderators
Making a paddle bow at Gregs
Spent the day at Gregs making(starting)my paddle bow.Got it shaped out roughly but we think the knot at near the top might be risky.First two photos are Gregs Osage takedown(wild bit of gear)But it shoots.Next few is the paddle bow in the rough with the knot in question near the top on one limb.
- Attachments
-
- DSCF2465.JPG (74.67 KiB) Viewed 1304 times
-
- DSCF2461.JPG (91.78 KiB) Viewed 1304 times
-
- DSCF2459.JPG (116.02 KiB) Viewed 1304 times
-
- DSCF2453.JPG (58.07 KiB) Viewed 1304 times
-
- DSCF2452.JPG (57.77 KiB) Viewed 1304 times
-
- DSCF2451.JPG (54.17 KiB) Viewed 1304 times
Slackshot aka Gary Case
- Gringa Bows
- Posts: 6331
- Joined: Thu Aug 30, 2007 7:09 pm
- Location: Bundaberg QLD
Re: Making a paddle bow at Gregs
Gary,the osage take down is a wild bit of gear alright,so's that monster you've been working on
- Gringa Bows
- Posts: 6331
- Joined: Thu Aug 30, 2007 7:09 pm
- Location: Bundaberg QLD
Re: Making a paddle bow at Gregs
What timber are you using in the paddle bow,is it brigalow or some other wattle
- Stickbow Hunter
- Supporter
- Posts: 11637
- Joined: Sat Jul 26, 2003 8:33 pm
- Location: Maryborough Queensland
Re: Making a paddle bow at Gregs
Toz's bow looks a roughy alright but if it shoots good no probs.
It looks like you would have made a bit of yella dust shaping that bow of yours. I couldn't see any knots that would cause any problems - in fact I could only make out one very small one.
Jeff
It looks like you would have made a bit of yella dust shaping that bow of yours. I couldn't see any knots that would cause any problems - in fact I could only make out one very small one.
Jeff
- Gringa Bows
- Posts: 6331
- Joined: Thu Aug 30, 2007 7:09 pm
- Location: Bundaberg QLD
Re: Making a paddle bow at Gregs
ahhh so its osage too,is it that colour because its still green.
Re: Making a paddle bow at Gregs
If I'm looking at the right knot - just as the limb tapers to the tip - no problems, leave it proud on the back and it will be fine
regards Jacko
regards Jacko
"To my deep morticication my father once said to me, 'You care for nothing but shooting, dogs and rat catching, and you will be a disgrace to yourself and all your family.' "
- Charles Darwin
- Charles Darwin
Re: Making a paddle bow at Gregs
AH! Paddle bow! I was wondering what on earth a paddle bow was, but now I get it.
Lately, if life were treating me any better, I'd be suspicious of it's motives!
Re: Making a paddle bow at Gregs
LB that piece of osage is about ten years old i think,i cut it about then and i remember the day well.My side kick set a couple of lines in the river and then went to sleep.Perry ive left it proud but it looks like its bending at the knot,,,,plus Greg is standing back as he does waiting with the wealth of knowledge that he has,did i say that i wipped into the belly and didnt listen about takeing the back down first.This is the first self bow iv made(maybe),,,,mmmm maybe it will end up as a Stickbow.
Slackshot aka Gary Case
- Gringa Bows
- Posts: 6331
- Joined: Thu Aug 30, 2007 7:09 pm
- Location: Bundaberg QLD
Re: Making a paddle bow at Gregs
10yrs old so thats why its that colour, i knew that
Re: Making a paddle bow at Gregs
Leave it proud on the belly aswell and it will be fine. Only trouble is it sounds like you are headed for a lighter draw than you wanted - OH well, every Selfbow is a learning curve and it looks like you have good guidance there - you'll be right
regards Jacko
regards Jacko
"To my deep morticication my father once said to me, 'You care for nothing but shooting, dogs and rat catching, and you will be a disgrace to yourself and all your family.' "
- Charles Darwin
- Charles Darwin
Re: Making a paddle bow at Gregs
Good to see some selfbows being made on this site again, i have been waiting for some self bowyer for a while. Good luck with the paddle bow slackshot. I have just finished a bend through the handle longbow #50 28" and i will post picks soon....Roscoe